Mbm-corporation Paper Drill 200 single spindle Manual de usuario

Due to possible damage in shipping, the vertical stop assembly has been removed from this machine. To assemble, insert the threaded rod through th

10METHOD NO. 2 1. Loosen the knob on the back gauge and set the margin you desire using the two scales embedded in the rear corners of the t

11 ILLUSTRATION #7 FOR STATIONARY TABLE DRILLING 1. Remove the setscrews from two adjacent stop collars and replace them with the longer

12MODEL 200 BENCH MODEL DRILL MAINTENANCE SCHEDULE LUBRICATION AND INSPECTION 1. Every two weeks: a. Remove the table by loosening th

13TROUBLE SHOOTING GUIDE PROBLEM: Drill bit not concentric. CAUSE Foreign material in chuck or on drill-plug. CORRECTION: Inspect and cle

14 ILLUSTRATION #6 A. Vertical Stop Knob B. Shroud Assembly C. Vertical Stop Lock Knob D. Motor E. Handle Assembly F. Pivot Arm

2 MODEL 200 BENCH MODEL DRILL 1. Remove the machine from the carton and inspect for any shipping damage. If any damage is present, report th

3 MODEL 200 BENCH MODEL DRILL STARTUP PROCEDURES 1. Refer to Back Gauge Scale Assembly (Illustration No. 1) and assemble back gauge assemb

4 2. Using Illustration No.2, install the Table Assembly (Illustration No. 3) to the body of the machine by sliding the table from left to

5 ILLUSTRATION #3 3. Install the Back Gauge Scale Assembly (Illustration No. 1) on the Table Assembly (Illustration No. 3). Grasp t

6 ILLUSTRATION #4 5. As in Illustration No. 3, install the paper side stops (B) to the table by inserting two paper side stop knobs throu

7 MODEL 200 BENCH MODEL DRILL REMOVAL, INSTALLATION, AND ADJUSTMENT OF DRILL BITS A. To remove a drill bit from the machine: 1. Remove t

8 TABLE SETUP AND DRILLING Following are two methods for setting up the table to drill a particular hole pattern in the material. The first

9 ILLUSTRATION #6 4. Using the hex key provided, loosen the setscrews in the stop collars on the stop bar. Loosen only the stop collars